Artikel Jurnal :: Kembali

Artikel Jurnal :: Kembali

Modeling of wedm parameters while machining mg-sic metal matrix composite

Raj Thakur, P Chetia, S.K. Tamang, S. Samanta (Faculty of Engineering, Universitas Indonesia, 2017)

 Abstrak

In this paper an attempt has been made to study the effects of the process parameters of wire cut electrical discharge machining (WEDM) on Magnesium-Silicon Carbide MMC with 5% SiC in particulate form. For the analysis, six factors, namely pulse on time, pulse off time, spark gap voltage, peak current, dielectric flushing pressure and servo feed have been taken and a Taguchi L16 orthogonal array for two levels was used. Response surface methodology was also used to develop second-order models for material removal rate (MRR) and surface roughness (SR). From the analysis of variances, it has been observed that pulse on time and pulse off time were the most significant parameters among all those observed in predicting the MRR and SR, respectively.

 Kata Kunci

 Metadata

Jenis Koleksi : Artikel Jurnal
No. Panggil : UI-IJTECH 8:5 (2017)
Entri utama-Nama orang :
Subjek :
Penerbitan : Depok: Faculty of Engineering, Universitas Indonesia, 2017
Sumber Pengatalogan : LibUI eng rda
ISSN : 20869614
Majalah/Jurnal : International Journal of Technology
Volume : Vol. 8, No. 5, October 2017: Hal. 878-886
Tipe Konten : text
Tipe Media : unmediated
Tipe Carrier : volume
Akses Elektronik : https://doi.org/10.14716/ijtech.v8i5.870
Institusi Pemilik : Universitas Indonesia
Lokasi : Perpustakaan UI, Lantai 4 R. Koleksi Jurnal
  • Ketersediaan
  • Ulasan
  • Sampul
No. Panggil No. Barkod Ketersediaan
UI-IJTECH 8:5 (2017) 08-23-86580077 TERSEDIA
Ulasan:
Tidak ada ulasan pada koleksi ini: 9999920533980
Cover