Hasil Pencarian  ::  Simpan CSV :: Kembali

"Fast pyrolysis biomassa dapat menghasilkan bio-oil dengan potensi aplikasi yang luas, salah satunya dapat digunakan sebagai bio-fuel. Sayangnya, bio-oil berbasis biomassa memiliki sifat fisikokimia yang buruk dan banyak mengandung senyawa oksigenat sehingga heating value-nya rendah. Plastik diketahui memiliki rasio H/C yang lebih tinggi dan miskin akan oksigen sehingga slow co-pyrolysis biomassa dengan plastik dapat digunakan sebagai solusi upgrading bio-oil yang sederhana, efektif dan murah. Dengan mencampurkan keduanya, sebuah efek sinergetik akan tercipta untuk memperbaiki kuantitas dan kualitas bio-oil yang dihasilkan. Bonggol jagung dipilih sebagai biomassa karena kandungan total selulosanya yang tinggi dan ketersediaannya yang melimpah di Indonesia. Bonggol jagung akan dipirolisis bersama-sama dengan plastik polipropilena dalam reaktor batch berpengaduk dengan variasi rasio plastik dalam umpan sebesar 12,5%, 25%, 37,5%, 50%, 62,5%, 75%, dan 87,5%. Kondisi operasi dengan suhu maksimum sebesar 500oC, laju alir N2 sebesar 0,5 L/menit, holding time 10 menit dan heating rate 5oC/menit digunakan selama eksperimen berlangsung. Terjadi peningkatan pH, densitas, dan warna pada bio-oil hasil slow co-pyrolysis. Karakterisasi GC-MS menunjukkan penurunan senyawa oksigenat di dalam bio-oil berbanding lurus dengan komposisi plastik dalam umpan. Efek sinergetik teramati saat rasio plastik ≥50%. Komposisi umpan 12,5% bonggol jagung dan 87,5% plastik PP menghasilkan yield tertinggi dengan kandungan senyawa oksigenat terendah.

---

Fast pyrolysis of biomass produces bio-oil with many potential applications, one of them is to be bio-fuel. Unfortunately, biomass derived bio-oil has low physicochemical properties and contains lot of oxygenated compounds thus the heating value is low. Plastics are known to have higher H/C ratio and almost no oxygen content, so co-pyrolysis of biomass and plastic could be used as a simple, effective yet cheap bio-oil upgrading solution. By mixing those two as a feed, a synergetic effect will occur and improve the bio-oil both in quantity and quality.

Corn cobs are chosen as the biomass due to its high cellulose content and availability. Corn cobs will be slow co-pyrolyzed with polypropylene plastic in a two stirrer batch reactor with plastic ratio variation of 12,5%, 25%, 37,5%, 50%, 62,5%, 75%, and 87,5%. Maximum temperature of 500oC, 0,5 L/min nitrogen flow, 10 minutes holding time and heating rate of 5oC/min was used in the experiment. pH, density, and color improvement were observed.

GC-MS results showed that lower oxygenated compounds in the bio-oil are associated with higher plastic feed composition. Synergetic effect is happened when plastic ratio is ≥50%. Composition of 12,5% corn cobs and 87,5% polypropylene plastic is found to produce the highest yield of bio-oil with the lowest oxygenates."

"Bonggol jagung merupakan limbah dengan jumlah yang cukup banyak di Indonesia. Sejauh ini pemanfaatan utama untuk biomassa. Namun biomassa tersebut masih mengalami kendala karena tingginya senyawa oksigenat yang menyebabkan heating value-nya rendah. Plastik polipropilena diketahui memiliki rasio H/C yang lebih tinggi dan miskin akan oksigen sehingga slow co-pyrolysis biomassa dengan plastik dapat digunakan sebagai solusi upgrading bio-oil yang sederhana, efektif dan murah. Pencampuran biomassa dan plastik akan menghasilkan efek sinergetik dalam memperbaiki kuantitas dan kualitas bio-oil yang dihasilkan. Berbagai penelitian pada slow co-pyrolysis telah dilakukan terutama pada reaktor tubular dengan rasio tinggi terhadap diameter, lebih dari 4. Tetapi untuk skala besar, bentuk reaktor seperti ini sangat sulit dilakukan scale-up. Pada penelitian ini reaktor dibuat dengan rasio kurang dari 2. Perpindahan panas khususnya pada plastik yang memiliki konduktivitas termal rendah dibantu dengan adanya pengaduk untuk memperbaiki persebaran perpindahan panas tersebut. Identifikasi pengaruh efek sinergetik dilakukan dengan menganalisis bio-oil menggunakan FTIR dan GC-MS. Efek sinergetik yield bio-oil terjadi pada komposisi PP terhadap bonggol jagung sebesar 50-87,5 dengan 87,5 sebagai yield tertinggi. Sementara efek sinergetik kualitas bio-oil yang berupa peningkatan senyawa non-oksigenat terjadi pada komposisi PP 37,5-87,5.

---

Corn cob is a waste which has considerable amount in Indonesia. So far, its utilization especially for biomass. However, biomass still having problems because the high oxygenate compound which causes low heating value. The pure polypropylene plastic has a H C ratio higher and poor in oxygen, so slow co pyrolysis of biomass with plastic can be used for bio oil upgrading solutions which is simple, effective and inexpensive. By mixing the two feedstocks, a synergetic effect would be created to improve the quantity and quality of the bio oil produced. Various studies on the slow co pyrolysis has been carried out mainly in the tubular reactor with a high ratio of the diameter, more than 4. But for large scale, that reactor design will be very difficult to scale up.

This research, reactor was made with a ratio less than 2. The heat transfer especially on the plastic that has a low thermal conductivity helped by stirrer to improve the distribution of heat transfer. Identification of the synergetic effect was done by analyzing bio oil using FTIR and GC MS. Synergetic effects of bio oil yield occurred in the composition of the PP towards corn cobs of 50 to 87.5 which 87.5 as the highest yield. While the synergetic effect of the quality in bio oil as an increase in the composition of the non oxygenate which exist in PP composition 37.5 to 87.5."

"Penelitian slow co-pyrolysis bonggol jagung dan plastik polipropilena telah dilakukan untuk mempelajari pengaruh laju alir gas pembawa terhadap yield dan komposisi bio-oil yang dihasilkan. Pengaruh laju alir gas pembawa diteliti dengan memvariasikan laju alir nitrogen sebesar 400 mL/menit, 500 mL/menit, dan 600 mL/menit dengan masing-masing variasi laju alir nitrogen dilakukan pada 3 rasio komposisi bonggol jagung dan plastik polipropilena, yaitu 0 :100 , 50 :50 , dan 100 :0 . Proses slow co-pyrolysis berlangsung di reaktor tangki berpengaduk, dengan suhu akhir 500°C, holding time 10 menit, heating rate 5oC/menit, dan total massa umpan 100 gram. Identifikasi pengaruh laju alir gas pembawa dilakukan dengan menganalisis bio-oil fasa polar dan nonpolar menggunakan FTIR, GC-MS, dan H-NMR. Hasil penelitian ini menunjukkan terdapat pengaruh laju alir gas pembawa terhadap yield dan komposisi bio-oil hasil slow co-pyrolysis bonggol jagung dan plastik polipropilena. Semakin besar laju alir nitrogen menghasilkan yield bio-oil yang semakin besar dan yield char yang semakin rendah. Yield bio-oil tertinggi sebesar 47,9 mL pada laju alir nitrogen 600 mL/menit, sedangkan efek sinergetik terbaik sebesar 35 pada laju alir nitrogen 400 mL/menit. Berdasarkan karakterisasi GC-MS dan H-NMR seiring semakin besar laju alir nitrogen maka gugus fungsi alkana semakin rendah dan alkena semakin tinggi pada bio-oil nonpolar, serta gugus fungsi karboksilat semakin rendah dan gugus fungsi furan, fenol, guaiacol, catechol semakin tinggi pada bio-oil polar.

---

Research that focused on slow co pyrolysis of corn cobs and polypropylene plastic has been done to study the effect of carrier gas flow rate on yield and composition of bio oil. The effect of carrier gas flow rate was investigated by varying nitrogen flow rate of 400 mL min, 500 mL min and 600 mL min with each variation performed on 3 ratio of corn cobs and polypropylene plastic are 0 100 , 50 50 , and 100 0 . The slow co pyrolysis process takes place in a stirred tank reactor, with final temperature of 500°C, holding time of 10 minutes, heating rate of 5oC min, and total mass of feed 100 grams. Identification of the effect of carrier gas flow rate is done by analyzing polar and nonpolar phase bio oil using FTIR, GC MS, and H NMR.

The results of this study indicate that there is an effect of carrier gas flow rate on yield and bio oil composition of slow co pyrolysis of corn cobs and polypropylene plastic. The greater the nitrogen flow rate results in greater bio oil yield and lower yield char. The highest bio oil yield was 47.9 mL at nitrogen flow rate of 600 mL min, while the best synergetic effect was 35 at nitrogen flow rate of 400 mL min. Based on the characterization of GC MS and H NMR as the greater the nitrogen flow rate the alkane functional group is lower and the higher the alkene in nonpolar bio oil, and the lower carboxylic functional groups and the furan, fenol, guaiacol, catechol functional groups are higher in polar bio oil. "

"Minyak kelapa sawit memiliki potensi yang tinggi untuk dikembangkan menjadi bio-oil oleh karena kandungan trigliserida. Indonesia merupakan negara produsen kelapa sawit terbesar di dunia. Selama ini minyak kelapa sawit belum dimanfaatkan secara maksimal khususnya sebagai bahan baku industri. Padahal minyak kelapa sawit dapat dimanfaatkan sebagai energi terbarukan melalui proses slow co-pyrolysis. Dalam penelitian ini, trigliserida yang digunakan dari minyak goreng kelapa sawit. Selain itu, limbah plastik juga berlimpah di Indonesia, terutama plastik polipropilena. Tujuan penelitian ini adalah untuk mengetahui pengaruh laju oenambahan plastik polipropilena terhadap yield dan kualitas bio-oil hasil slow co-pyrolysis minyak kelapa sawit. Penelitian ini dilakukan dalam reactor tabung berpengaduk pada suhu 550oC, heating rate 5oC/menit, kecepatan pengaduk 65 RPM dengan laju alir gas nitrogen 550 mL/min. Variasi yang dilakukan berupa penambahan jumlah % massa plastik polipropilena yang akan mempengaruhi yield dan komposisi dari bio-oil yang dihasilkan. Bio-oil dikarakterisasi dengan menggunakan GC-MS, dan FTIR. Efek sinergetik pada pirolisis PP-trigliserida tidak terjadi, sedangkan pada pirolisis PP-bonggol jagung terjadi saat komposisi PP 50% dan 75%. Bio-oil optimum dihasilkan pada komposisi PP 75% baik pada pirolisis PP-trigliserida dan PP-bonggol jagung.

---

Palm oil has high potential to be developed into bio-oil because of the content of triglycerides. Indonesia is the largest palm oil producer in the world. So far, palm oil has not been fully utilized, especially as an industrial raw material. Even though palm oil can be used as renewable energy through the slow co-pyrolysis process. In this study, the the triglyceride is from palm oil cooking oil. In addition, plastic waste is also abundant in Indonesia, especially polypropylene plastic. The purpose of this study was to determine the effect of the rate of addition of polypropylene plastic on the yield and quality of bio-oil produced by slow co-pyrolysis of palm oil. This research was conducted in a stirred tube reactor at a temperature of 550oC, heating rate of 5oC / minute, stirrer speed of 65 RPM with a nitrogen gas flow rate of 550 mL / min. The variation is in the form of increasing the mass% of polypropylene plastic which will affect the yield and composition of the bio-oil produced. Bio-oil is characterized by using GC-MS, and FTIR. The synergetic effect on PP-triglyceride pyrolysis did not occur, whereas in the pyrolysis of PP-corn hump occurred when the composition of PP was 50% and 75%. Optimum Bio-oil was produced in the composition of PP 75% both in PP-triglyceride pyrolysis and PP-corncobs.

"