Bicycle wheel truing system
(Fakultas Teknik Universitas Indonesia, 2004)
|
| The primary aim of this project was to design a device that can be used as a bicycle wheel truer. The project system will allow a wheel's current state to be measured and analysed using strain gauges to detect the degree of wobble and eccentricity. The strain gauges will produce a small voltage as its means of detection, so an amplifier needs to be designed to boost the signal level for increased measurement resolution. The system also requires some means of holding the bicycle wheel securely while it is being tested. The test results from the system will provide information about the extent of the wobble and eccentricity that occur in the wheel. |
 S-Mulki Sulaiman Kusumaputra.pdf :: Unduh |
| No. Panggil : | S-Pdf |
| Entri tambahan-Nama badan : | |
| Subjek : | |
| Penerbitan : | [Place of publication not identified]: Fakultas Teknik Universitas Indonesia, 2004 |
| Program Studi : |
| Bahasa : | eng |
| Sumber Pengatalogan : | |
| Tipe Konten : | |
| Tipe Media : | |
| Tipe Carrier : | |
| Deskripsi Fisik : | viii, 22 p. : ill. ; 30 cm. |
| Naskah Ringkas : | |
| Lembaga Pemilik : | Universitas Indonesia |
| Lokasi : | Perpustakaan Universitas Indonesia |
| No. Panggil | No. Barkod | Ketersediaan |
|---|---|---|
| S-Pdf | TERSEDIA |
| Ulasan: |
| Tidak ada ulasan pada koleksi ini: 20244383 |
