ABSTRAK Penambahan plastik pada pyrolysis tongkol jagung dapat dijadikan salah satu carauntuk meningkatkan yield biooil dan kandungan senyawa non-oxygenate dalambiooil. Penelitian ini bertujuan untuk mengevaluasi efek dari penambahan plastikpada pyrolysis biomassa terhadap yield dan kualitas biooil serta pengaruh holdingtime terhadap biooil hasil proses co-pyrolysis tongkol jagung dan limbah plastikdalam reaktor unggun tetap. Temperatur maksimal yang digunakan adalah 500oC.Kecepatan alir N2 yang digunakan 700 ml/menit dan kecepatan pemanasan rendah5oC/menit. Kecepatan alir N2 dan kecepatan pemanasan co-pyrolysis dibuatrendah untuk mengakomodasi yield biooil yang tinggi dari pyrolysis plastik.Tongkol jagung memiliki kandungan selulosa dan hemiselulosa sebesar 81,3%dimana sangat potensial untuk menghasilkan biooil. Variasi rasio berat plastikdalam campuran umpan adalah 0, 25, 50, 75, dan 100% dan holding time 0, 10,30, 50, dan 70 menit. Yield biooil yang diperoleh pada co-pyrolysis tongkoljagung dan plastik semakin menurun dengan semakin besarnya rasio berat plastikpada campuran umpan, High Density Polyethylene (HDPE) sebesar 20,28, 17,70,17,95, 10,45, dan 7,66 % berat dan Polypropylene (PP) sebesar 20,28, 20,80,18,05, 8,10, 13,98 % berat. Tidak terjadi efek sinergitas untuk meningkatkan yieldbiooil. Efek sinergitas terjadi menyebabkan peningkatan senyawa non-oxygenatebiooil hasil co-pyrolysis dengan rasio berat plastik terhadap campuran umpanyang tinggi. Penambahan holding time pada co-pyrolysis tongkol jagung danplastik cenderung menurunkan yield biooil dan kandungan non-oxygenate biooil. ABSTRACT The addition of plastic on the pyrolysis of corn cobs can be one way to increasethe yield biooil and non-oxygenate compound in biooil. This study aimed toevaluate the effects of adding plastic on pyrolysis of biomass to yield and qualityof biooil and the effect of holding time on biooil from co-pyrolysis corncobs andplastic waste on a fixed bed reactor. The maximum temperature used is 500oC.The flow rate of N2 used 700 ml/min and a low heating rate of 5°C / min. Theflow rate of N2 and co-pyrolysis heating rates are set low to accommodate biooilhigh yields of pyrolysis plastic. Corncob contains cellulose and hemicellulose of81.3% which is very potential to generate biooil. Variations in the weight ratio ofplastic in the feed mixture is 0, 25, 50, 75, and 100% and a holding time of 0, 10,30, 50 and 70 minutes. Yield biooil obtained in co-pyrolysis of corn cobs andplastics decreases with greater weight ratio of plastic in the feed mixture, themixture with High Density Polyethylene (HDPE) produced 20,28, 17,70, 17,95,10,45, and 7,66% by weight biooil and with Polypropylene (PP) produced 20,28,20,80, 18,05, 8,10, 13,98% by weight biooil. A synergy effects was not happenedto increase yield of biooil. Synergy effects occur causing an increase in nonoxygenatecompound biooil result of co-pyrolysis with a high weight ratio ofplastic to feed mixture. Addition holding time in the co-pyrolysis of corn cobs andplastic tends to decrease the yield biooil and non-oxygenate content biooil. |