A comparative study on electroplating of fdm parts
Md. Israr Equbal, Anoop Kumar Sood, Md. Asif Equbal (Faculty of Engineering, Universitas Indonesia, 2017)
|
| Electroplating on fused deposition modeling parts through two different routes is presented in the study. One route follows the conventional method of electroplating using chromic acid for surface preparation or etching and the other route uses the novel method of electroplating using aluminium charcoal (Al-C) paste for surface preparation. Same plating conditions are used for both the routes employed. The result proposes that instead of shell cracking in few electroplated samples, Al-C route is also capable of producing good copper deposition on FDM samples. Cracks may develop in few samples electroplated through Al-C route, because of dissolution of paste at high operating condition during electroplating. Proper drying of electrolessly plated samples and adaptation of suitable operating condition reduces the risk of electroplated shell cracking. |
| No. Panggil : | UI-IJTECH 8:5 (2017) |
| Entri utama-Nama orang : | |
| Subjek : | |
| Penerbitan : | Depok: Faculty of Engineering, Universitas Indonesia, 2017 |
| Sumber Pengatalogan : | LibUI eng rda |
| ISSN : | 20869614 |
| Majalah/Jurnal : | International Journal of Technology |
| Volume : | Vol. 8, No. 5, October 2017: Hal. 930-938 |
| Tipe Konten : | text |
| Tipe Media : | unmediated |
| Tipe Carrier : | volume |
| Akses Elektronik : | https://doi.org/10.14716/ijtech.v8i5.875 |
| Institusi Pemilik : | Universitas Indonesia |
| Lokasi : | Perpustakaan UI, Lantai 4 R. Koleksi Jurnal |
| No. Panggil | No. Barkod | Ketersediaan |
|---|---|---|
| UI-IJTECH 8:5 (2017) | 08-23-13529899 | TERSEDIA |
| Ulasan: |
| Tidak ada ulasan pada koleksi ini: 9999920534025 |
